Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
Submitted byAnonymouson12-03-201903:40 PM
Status:
Gathering Support
Smoother limits of Section view
As you can see, ends of section line C-C is equally positioned related to center mark. But in Section View C-C, you can see that limits are not the same on left side as on the right side, they are too rough, and they cannot be adjusted like it is possible in Break View. I suggest improving this in future versions
I have run into this problem as well. I'm finding that often the pattern of the jagged boundary is simply too large for the view. This can end up either showing material that I wanted cut off, or cutting off material that I want shown.
I often find that I have to go back to the old method of drawing in my own boundary and cropping the view.
