Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
Submitted byAnonymouson02-21-202001:02 AM
Status:
Gathering Support
Cable and harness
When editing existing wires in cable and harness, Inventor does not give an error message if you change to a bigger diameter wire and the sweep bending radius is to small for given wire. Thus you do not know why the wire reverts to the smaller diameter.
