Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
I am wondering if I can take a half funnel shape a rolled part and make it a flat pattern. I read that if I started with the end view and revolved it that I would be able to,
but that didn't work for me. Can you Help?
First off delete your current flat pattern, then select the outer face of
part, then flatten the part.
"lmtdnew" wrote in message news:5949870@discussion.autodesk.com...
> I am wondering if I can take a half funnel shape a rolled part and make it
> a flat pattern. I read that if I started with the end view and revolved it
> that I would be able to,
> but that didn't work for me. Can you Help?
>
Oops never mind about deleting your current flat pattern, I see that there
isn't one yet.
Just select the outer face then flatten the part
"Troy Grose" wrote in message
news:5949888@discussion.autodesk.com...
> First off delete your current flat pattern, then select the outer face of
> part, then flatten the part.
>
> "lmtdnew" wrote in message news:5949870@discussion.autodesk.com...
>> I am wondering if I can take a half funnel shape a rolled part and make
>> it
>> a flat pattern. I read that if I started with the end view and revolved
>> it
>> that I would be able to,
>> but that didn't work for me. Can you Help?
>>
>
I think I would model it a bit differently. The way you have modeled it the flat will have beveled edges along the arcs - more expensive to manufacture.
----------------------------------------------------------------------------------------- Autodesk Inventor 2019 Certified Professional Autodesk AutoCAD 2013 Certified Professional Certified SolidWorks Professional
Here is how I would probably do the model.
Pull down the red End of Folded marker and then double click on the Flat Pattern.
----------------------------------------------------------------------------------------- Autodesk Inventor 2019 Certified Professional Autodesk AutoCAD 2013 Certified Professional Certified SolidWorks Professional
But you should redraw it, like JD showed in his posted part. You are most
likely not going to manufacture the part like you drew it, so I would redraw
it like you are going to manufacture it.
"lmtdnew" wrote in message news:5950042@discussion.autodesk.com...
> Thanks! I didn't know it was going to be that eazy.
> Thanks again
>
