Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
I am trying to create a rolled cone in sheetmetal. The cone is open at the
top and bottom. I am creating an angled section of the proper width and
then revolving it around the centerline 359 degrees. The model appears
correct, however I am unable to unfold(unroll) it without getting an error
message. Is this something that is possible to accomplish?
Selecting the outer face and then generating the flat pattern worked. I
wasn't sure what you meant by sketching on the top face though. Was I
supposed to revolve 360 degrees and then cut out a slice?
"John Bilton" wrote in message
news:C8FE6B6437609D3CA68F3A833DEDC19C@in.WebX.maYIadrTaRb...
> Make sure you have modelled the split line - Sketch on top face,
rectangle - extrude - cut - all.
>
> Select the outer face with your mouse then issue the flat pattern command.
>
> John Bilton
>
