Need help with modeling

[Ivan_Sinicyn]

Guys,
help me with the construction of this design. Thought it would be easy, but I don't understand how to do the rounding on the corners🙉

[kacper.suchomski · Accepted solution]

Hi

Look this:

[Anonymous · Accepted solution]

" but I don't understand how to do the rounding on the corners"

I assume you mean the bent "wire" type item located on the origins of the base plates radius', correct?

Your best bet is to construct such as a 3D sketch, then locate the profile on the base plate at the intersection point of it and the 3D line you just created and sweep it along that 3D line (make sure the bend automatically put into the 3D sketch line is large enough for the profile to sweep around it and not overlap itself..

I doubt that is very clear, just don't have the time to demonstrate.

[CCarreiras · Accepted solution]

Hi!

You have to do an intersection between 2D curves:

Check the part attached

[Frederick_Law]

The corner round will not be banana.

[CCarreiras · Accepted solution]

Since you have several parts in the model, it would be better if you create an assembly...

Check the assembly file...

[Ivan_Sinicyn]

Guys, you're the best!

Thanks a lot, everybody!

[Anonymous]

---

@Frederick_Law wrote:

The corner round will not be banana.

---

No, but it might be a pineapple.

[Frederick_Law]

As long as not an angry pineapple .....