Mass with model state

[ZFerrarini]

I created a part with few model states in Inventor 2023.

I would like to create a table with the mass of every model state.

Is it possible?

thank you in advance.

[ZFerrarini]

I created a part with few model states in Inventor 2023.

I would like to create a table with the mass of every model state.

Is it possible?

thank you in advance.

[blandb]

This might help lead you:

https://www.autodesk.com/support/technical/article/caas/sfdcarticles/sfdcarticles/How-add-mass-of-ea... 

[blandb]

This might help lead you:

https://www.autodesk.com/support/technical/article/caas/sfdcarticles/sfdcarticles/How-add-mass-of-ea... 

[ZFerrarini]

I am not sure what iLogic code I need to write.

[ZFerrarini]

I am not sure what iLogic code I need to write.

[blandb · Accepted solution]

at the bottom, if you click on the "ilogic mass update properties" link in the ilogic section, it brings up this form where a user has written some code. I have attached that forum post below.

https://forums.autodesk.com/t5/inventor-programming-ilogic/ilogic-mass-properties-update/td-p/357151... 

[blandb · Accepted solution]

at the bottom, if you click on the "ilogic mass update properties" link in the ilogic section, it brings up this form where a user has written some code. I have attached that forum post below.

https://forums.autodesk.com/t5/inventor-programming-ilogic/ilogic-mass-properties-update/td-p/357151... 

[ZFerrarini]

Thank you.

[ZFerrarini]

Thank you.