ISSUE!!! There is a mismatch between study definition and the study result data stored in,,,,,

[Francisco_ElenesGELGS]

Multiple times when I run a Stress Analysis simulation, do a check-in close the assembly file, opening back again & go to "Stress Analysis" to review the study's results, I get this message and have to re-run simulation again.

This totally sucks, time is wasted...

Is there a solution or workaround to this issue?

[johnsonshiue]

Hi! Please take a look at the following discussion and see if it helps.

https://forums.autodesk.com/t5/inventor-forum/mismatch-between-the-simulation-definition-and-the-sim...

Many thanks!