Is there any way to create a pattern of concentric arcs (or circles)? I wish to make a grill which would be adapting based on parameters such as count of ribs, several dimensions, etc. I can't figure out a way to make the arcs concentric and spaced by defined distance 😕
Yup, I know I can do that. However I want it to be adjustable using a pattern.
Think of it as if it was at design stage and I wanted to adjust number of ribs and their dimensions. And it was much bigger - could have anywhere between 10 and 100 ribs. Or if I needed several versions with wildly different amount of ribs. You wouldn't like to make that many individual ribs, constrain each of them and pick each for replace face tool.
If you make your largest arc (towards the outer edge) terminate at the bounds of your yellow profile, then you could linear pattern that towards the center, adjusting the spacing and count. Now you can go and add the new arcs to the grill > Rib section. Draw back, you have to manually add as necessary. If you start with a full section of ribs, then decide to remove, it will bark. Manage > rebuild all does nothing, but if you edit the grill and then just click ok, it will fix itself.
Please see attached video for clarification, not sure if this would save much time or not lol.
