Inventor Studio Render Drive

[Anonymous]

So here I have a spring in Inventor Studio. It was made with the Adaptive settings in mind and the two blocks on the top and bottom are constraints to the spring. I can make it go up and down using the Drive tool. 

Is it possible to render this in full quality in Inventor Studio?

[Anonymous]

So here I have a spring in Inventor Studio. It was made with the Adaptive settings in mind and the two blocks on the top and bottom are constraints to the spring. I can make it go up and down using the Drive tool. 

Is it possible to render this in full quality in Inventor Studio?

[Xun.Zhang · Accepted solution]

Hello @Anonymous,

It is doable after entering Inventor studio by Constraint Animation.

Hope it helps!

[Xun.Zhang · Accepted solution]

Hello @Anonymous,

It is doable after entering Inventor studio by Constraint Animation.

Hope it helps!

[Anonymous]

It isn't working. Only the spring moves up and down despite it being constrained to top and bottom blocks.

[Anonymous]

It isn't working. Only the spring moves up and down despite it being constrained to top and bottom blocks.

[Anonymous]

Found the problem! I was animating the wrong constraints.

[Anonymous]

Found the problem! I was animating the wrong constraints.