As i going deeper in deeper in Inventor I now finally beginning to understand why many Solidworks user that previously use inventor says that Inventor is a 5 years old behind. As of today i'm doing a dynamic simulation and i found out that dynamics simulation does not make sense because i cannot select a face where i will put a force but instead i can only pick vertex, circular edge, arc edge, sketch point, sketch circle, sketch arc, line end point, work point. If i select the outside circular edge it will be offset at the center plane which create a moment which is not desired, unless inventor hiding a way to do it. (most of all its not a user Friendly)
Inventor Dynamics Simulation (Force Location)
Not Exactly the same with solidworks it's more like the opposite if solidworks do the job in left direction inventor will do the job in right direction, and i'm familiar with solidworks motion study in motion study you can select anything which will give you more control. here is a sample of my project i want a 1000N in the hole with the read mark and the direction will be normal to the XY Plane thanks
Hi Marlon,
Admaiora
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
Facebook | Twitter | Youtube