How do I save how Inventor GUI is setup up ?

[Darkforce_the_ilogic_guy]

I want to save how my Model Browser is locate and it size in inventor.  and I want Layout Browser not to be there when I start up Inventor because I never use it . how do I get inventor to save this. So it is as i want it to been next time I open inventor on my PC ?

[Mark.Lancaster]

@Darkforce_the_ilogic_guy 

The interface is stored in the registry when you exit Inventor.

The layout browser?   Are you talking the Factory Design Utility interface?

Also what version of Inventor are you using?  And what updates have you applied to Inventor?

[Darkforce_the_ilogic_guy]

it is inventor 2020.2. My problem is that it do not save when exit for some reason. It did when we where running 2018.

But it do not do it now

It is Layout browser.. that none of us using it .. look at picture below

And this is how it look then i close inventor

and this is want it look like when inventor open again ... it have change my setting (it have chance the ordre of my tabs)