Frame generator problem miter

[RadoG]

Frame generator problem miter see picture. This command not work correctly I want these edges to be aligned.

[mdavis22569]

Can you share the files?

Update(s) installed? 

What happens if you try this:

[JDMather]

It doesn’t look like the frame members were placed properly before 

[RadoG]

I want these edges to be aligned. I will  cut free  edge. I want result from picture command.

[JDMather]

Like this (see Attached)?

[RadoG]

I want this result from this command. how to make ?

[JDMather]

Inventor isn't going to change the position on you.

You must enter the 10mm Offset...

[RadoG]

This is not decision . How work command  offset direction in miter. Why result is equal and only change picture command.

[JDMather]

Wrong tool, not offset in Miter - that controls gap.

You need to Offset in placement.

[JDMather]

Ping @johnsonshiue 

You might want to take a look at this one.

Yesterday I did not properly exercise this as I did not have DIN standard.

Today I reproduced with ISO standard and got unexpected results when I used Miter.

So then I use an assembly level cut to get what I think was the OP's design intent.

[3D4Play]

IFF the miter angle does not matter, then use the full miter cut option:

[johnsonshiue]

Hi Guys,

The behavior does look inconsistent. I cannot explain it either. It looks like a bug to me. Let me work with the project team to understand it better.

Many thanks!