Hello, i made a metal drawer using sheet command. I used flange to make sides, but one side is a little bigger i extended it using olso flange command. (you can see it in first foto). In 3D everything looks okay for me, but if i go to flat pattern, i see strange corners (second foto). if i want to cut the metal and later to bend it, will it be a problem? Inventor doest give me any error when i make flat pattern. Iam new to sketching, so please give me advice. Thank you.
Solved! Go to Solution.
Solved by johnsonshiue. Go to Solution.
Solved by IgorMir. Go to Solution.
Attach your *.ipt file here.
Hi Jonas;
It appears - there is a problem with the Flat Pattern module. I can reproduce the error easily. The Flat Pattern should look like the one in the attached file. Why there is an error in the Flat Pattern in your file - I don't know. The model is legitimate, as far as I am concerned.
Cheers,
Igor.
Hi! The flat pattern does not look right, though the default Corner relief was set to Tear. It does look like Tear, However, if I change it to a different type, the corner release looks the same, which is wrong.
Many thanks!
Can't find what you're looking for? Ask the community or share your knowledge.