Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
In the attached file I have created a section view A-A. I origionally created the dtail and them added the fillets. Due to the fact that the section line runs straight through the fillet it screws up my detail for section A-A. Does anyone know if it is possible to show the Section view as if the fillet were not there without actually suppressing the fillet. I am using IV2009. Any suggestions would be appreciated.
Edited by: TRICOFRANKLIN on Jan 20, 2009 4:54 PM
I am assuming you never got a response to your question. That is a problem I commonly have and curious as to whether you ever found a solution. Sectioning through fillets gives you useless sections!
