Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

fillet help

Anonymous

fillet help

Anonymous
Not applicable

how do you get a fillet to go through two separate extrusions, how do i get the fillet to look like the first photo (green), instead of the second photo (red), where the fillet cuts off after one extrusion. please help, thank you

 

IMG_1232.JPGIMG_1233.JPG

0 Likes
Reply
Accepted solutions (1)
578 Views
5 Replies
Replies (5)

JDMather
Consultant
Consultant

Can you Attach your *.ipt file here?


-----------------------------------------------------------------------------------------
Autodesk Inventor 2019 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional


Anonymous
Not applicable

attached below, thanks

0 Likes

JDMather
Consultant
Consultant

You should install the latest Updates for 2018, while I take a look at possible solutions.

 

Because you have a taper on Extrusion1 - if you zoom in close you will notice a difference with your arc.

My first guess is going to be Face Fillet rather than Edge Fillet, but I need to do some testing...


-----------------------------------------------------------------------------------------
Autodesk Inventor 2019 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional


0 Likes

JDMather
Consultant
Consultant
Accepted solution

See Attached.


-----------------------------------------------------------------------------------------
Autodesk Inventor 2019 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional


Anonymous
Not applicable

thank you!

0 Likes

Type a product name