Dowel hole from midplane

[sbalasubramanianJJDFU]

Hello All,

I am trying to create an ifeature hole for dowel pin from midplane with two different diameters and depth in either direction. Appreciate some guidance and direction for this case. thanks!

[Frederick_Law]

Which will cut into 2 different parts?

You'll need 2 iFeatures.

[sbalasubramanianJJDFU]

It cuts into single part but in two directions with different dia and depth either side

[Frederick_Law]

Then create it the way you'll in normal part.

[sbalasubramanianJJDFU]

Is it possible to create ifeature with different diameter holes in opposite direction with different depths?

[Frederick_Law]

Yes, if you can model it in the part, you can make iFeature.