Diagonal Constraint Interference

[JDP2]

Good Afternoon,

I am making a structure (please see attachments) that has several cross-braces attached to the  main frame.

The cross-braces intersect each other, causing an interference.

Is there a way to diagonally-constrain the cross-braces without intersecting them?

My drawing is not affected in any way by the interference, my concern is purely cosmetic.

Thank you.

Regards,

Josue de Paz

[JDMather · Accepted solution]

I would assemble them exactly the same way that they are assembled in the real world.

I would not be able to sleep at night with the parts not assembled correctly.

[JDP2]

Good Morning JDMather,

Based on your answer I will assume that there is no way to remove the interference.

I will definitely assemble the parts correctly.

Thank you.

Regards,

Josue de Paz

[JDMather]

The way to remove the interference is to assemble the components exactly like they would be assembled in the real world.

[johnsonshiue]

Hi! Drawing in your case may look Ok with interference. But, I have seen cases that some components are not properly included or edges are missing due to pre-existing interference. I personally think the assemblies and parts should always be ideal build. Any imperfection can lead to unforeseen downstream issues.

Many thanks!

[JDP2]

Hello Johnson Shiue,

 I constrained the second cross-brace with an offset to clear the first one. The resulting gap is very small.

In the real world the gap would be removed when the cross-braces are tightened, or by adding a washer.

Regards,

Josue de Paz