You can see video sketch is full constrained. But my sketch is not. Please identify the error.
My sketch:
Video sketch:
https://www.youtube.com/watch?v=qh1WZ6EVSuY
Time 1:05
Solved! Go to Solution.
Solved by IgorMir. Go to Solution.
Solved by mdavis22569. Go to Solution.
just an FYI ..at .1:03 ...he says ...Lets step ahead, he edited out what he was doing. He goes from 8 to 0 constraints in a sec ..
So it's hard to know exactly what he's doing. We can constrain it ourselves but I won't be the same as him
All I did was add a mid point and the arc constraint to make it fully contrained
You can do away with 500mm. dimension. Equal constrain (=) should be sufficient in this occasion. It will give you less entries in the Parameters list.
Cheers,
Igor.
@mdavis22569 wrote:
just an FYI ..at .1:03 ...he says ...Lets step ahead, he edited out what he was doing. He goes from 8 to 0 constraints in a sec ..
So it's hard to know exactly what he's doing. We can constrain it ourselves but I won't be the same as him
All I did was add a mid point and the arc constraint to make it fully contrained
I put the .500 in so he knew that's what I was doing. The original value he had was .649. I didn't know if it was .500 .... however I did confirm that the 2 .500 were equal ...
Can't find what you're looking for? Ask the community or share your knowledge.