Can't see dimention in the Sketch

[Anonymous]

Hi,

This is the second time this has happend...

While putting in the dimension on the rectangle,

The dimenition just dosn't apear!

But it can be changed.

When this happen's I just delet and reopen another part.

Why is this, and, can this be changed?

Thanks,

Sophie

[JDMather]

Have you installed all Service Packs and Hot Fixes?

Are you aware that you are working in inch units (but this isn't the problem) rather than metric units?

[Anonymous]

Something very odd with the sketch! Deleting a dim leaves it on the screen until you Finish the sketch. Add a new sketch on a different plane, sketch can be made but entities are invisible until sketch is Finished. New sketch seems to consume previosu sketch as there is only 1 sketch in the tree.

Fully patched Inv 2013. No use attaching my copy of this file as original is earlier release.

[Logos_Atum]

When opening the sketch no dimensions are shown.

After changing to the sketch level, cdouble clicking one

of the dimensions, all of them are shown.

Therefore I can´t quite help you to answer your question.

[Anonymous]

Ok, thanks everyone for trying to help me out!

I see now it is realy a bug...

Thanks,

Sophie

[mrattray]

This is interesting. It seems as though every one of us is getting slightly different behavior.

Upon opening part:

Upon entering sketch edit:

All dimensions remain visible (except for extension lines) and editable after entering and exiting sketch edit:

Brendan's reported behavior is not reproducible on my machine:

Using 2013 SP 1.1 Update 2

The Idea Station is, apparently, the place to post bugs now.

[rdyson]

Rebuild All SEEMS to fix it, although the dim arrows are reversed. A new sketch looks to be correct.

[JDMather]

---

@Anonymous wrote:

Ok, thanks everyone for trying to help me out!

I see now it is realy a bug...

---

The big question is, "Is this occuring in any new file you create, or even ittermitently, or only in this file?

If you start a new file can you reproduce this behavior?

Is this new behavior, did it previously work fine?

Edit, I see you wrote this is the second time.  Install the SPs and report back if it re-occurs.

[johnsonshiue]

Hi! It seems like the dimension disply is corrupted. I have seen a few cases like this before but I am not able to find the steps to reproduce the behavior. Is any of the dimension modified via Inventor API or iLogic rule? Are you able to reproduce the behavior?

Thanks!