Can't get sweep to work on 3D skecthes using path and rail or path and surface.
I can get it to work on the yellow ...but now the green ...
Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.
---------
Mike Davis
Hi Brian,
There are a few places I would do differently. Please take a look at attached part. First, sketch3 is not constrained properly. The spline should be at least tangent continuous all around.. Second, this is a symmetric part. You don't need to model the whole thing. Just create one side and then mirror the other half. Lastly, sweeping as a solid may limit your choice in terms of intersection. I used surface sweep to create outer surface. Then use sculpt command to turn it back to a solid. Let me know if you have any question.
Many thanks!
Johnson Shiue (johnson.shiue@autodesk.com)
Software Test Engineer