Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

Auger flights flat pattern

Anonymous

Auger flights flat pattern

Anonymous
Not applicable

Hi all,

 

Need to make flat patterns for each flight. 8 flights total.

I have tryed doing them one by one but Inventor is telling me that "no bends found, nothint to compute" when i try the create flat pattern option. Also. I am not able to select any face when trying to define A-side.

Any ideas?

Inventor 2021

 

Thanks

0 Likes
Reply
Accepted solutions (1)
1,603 Views
4 Replies
Replies (4)

mikejones
Collaborator
Collaborator

Can you attached your attempt at it here

 

Mike

Autodesk Certified Professional
0 Likes

andrewdroth
Advisor
Advisor
Accepted solution

@Anonymous 

 

Check this out.

https://forums.autodesk.com/t5/inventor-forum/coil-to-flat-pattern/td-p/5934441


Andrew Roth
rothmech.com

YouTube IconLinkedIn Icon


IV2025 Pro
Apple IIe Workstation
65C02 1.023 MHz, 64 KB RAM
Apple DOS 3.3

Anonymous
Not applicable

I was creating something similar and was able to use a surface loft between 2 3D sketches followed by a thicken of the surface. It did create a flat pattern accurate enough for us to laser and use. This technique might be in the link posted, I saw 3D sketches were mentioned there.

 

Hope this helps!

Anonymous
Not applicable

worked perfectly. tanks!

0 Likes

Type a product name