2 sketch following Path - How ?

[steenH797P]

How to make a transition between 2 sketches, but which must follow a Path

See the picture
There should be a transition between A and B, but should follow Path (the round corner.)

[andrewiv]

You have to add the paths to the loft command.  I think you will need 4 paths for this, the edges of the part along the base of the loft and also create a sketch and project edges along the top of the loft.  Take a look at how this was done in Inventor 2020

[steenH797P]

Thanks for your answer.

I can't figure out your workflow.

Is it possible to make a small video that shows full process?

[JDMather]

Can you Attach your file here?

Make up a dummy file if you actual design in proprietary.

[andrewiv · Accepted solution]

Here is a recording of how I did this.

[johnsonshiue]

Hi! Actually this case may be solved by using Delete Face -> Heal. Basically, you just delete the two highlighted faces and let the adjacent faces re-intersect. Then you can apply a fillet to round of the edges.

Many thanks!

[steenH797P]

Can't see it for me what you mean. 😟 😕

[JDMather]

---

@steenH797P wrote:

Can't see it for me what you mean. 😟 😕

---

Attach your *.ipt file here for demonstration.