Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
Swap our girders/tunnels and keep slice information
Values can be reset to the defaults for that member… but the slices should remain on the girder and in the same locations.
Ideally, if some of the parameter names are the same, it would also retain the original values that each of the slices had for the parameters that match.
