Post Processor for Mazak VCN-530C

[djv-design]

Hello,

Looking for a PP for the above machine. None of the more generic ones seem to work properly on this mill, and I am a novice at this. Any help is appreciated!

Thanks!

[Arun.rs]

HI @djv-design 

Did you tried generic Mazak post in F360 libary ? https://cam.autodesk.com/hsmposts?p=mazak

Could you please tell what is not working on machine ?

Regards

[djv-design]

That one would not run on the machine in question. However, I found this post for VC500 that works for the most part (attached).

This post is for a 5-axis machine, but functions and I was able to make an accurate part. Can the post be edited to eliminate the A- and C-axis portions, as well as an M152 command replacing the X and Y homes at the end? Any help would be greatly appreciated.