Need help removing G94 from my Post

[bobsindorf]

Hello,

I'm having trouble editing my post processor and could use some help.  After a canned drilling cycle my post will output a G94 on the same line as G80. When my control sees the G94 it alarms out so what I'd like to do is remove the G94 after the canned cycle altogether but I can't find where in my post it is located. Any help would be much appreciated.

Thanks in advance.

[Anonymous]

need to know what post, can you share your post.

[bobsindorf]

This is the post I'm using right now. It is one of the generic Fanuc posts included with Fusion that I edited a little for my control.

[bobsindorf]

Nevermind, I found what I was looking for.