Need a post processor for older Mazak 1987. Using Fusion 360

[aniffenegger]

Looking for a post processor for a Mazak VQC-20/50B. It has a Mazatrol CAM M2 on the front of the control. We are trying to get fusion 360 to work with this old dog.

Thanks 

[ArjanDijk]

Yes,

I created a post for this machine for a customer. Do you have it already connected to a PC? This was a bit of a struggle with the Mazak RS232 ports as I remember. 

This customer has a few old Mazak, both M32 and CAM-M2. We created a seperate post for both of them.

please send me PM if you are interested. Where are you located?

[aniffenegger]

Yes it's connected to a PC. We are located in Wisconsin U.S. We have been using the machine for several years using OneCNC software, but we have transitioned to Fusion 360 and they don't have a post to use on this old of a machine. Please help.

[Anonymous]

Hi,
Can you contact me at [email protected] ?

Thanks

[ArjanDijk]

@Anonymous. Send you an email

[jromaniv]

Hi, I need that postprocessor. Help me, please.

[Anonymous · Accepted solution]

this post will only run in inches. however it does work with our Cam-m2.

[precisioncore]

This worked like magic for my 1996 Mazak HTC 400 Horizontal machine.
Thank you so much for the Post!