Mazatrol M plus post processor

[Anonymous]

Hi everyone. 

Does anyone have a post processor for my Mazak VTC 20B (control: mazatrol M-plus)? 

Thank you for your support in advance

[Arun.rs · Accepted solution]

HI @Anonymous 

Thanks for raising your concern via Forum.

There is no specific post for 'Mazak VTC 20B (control: mazatrol M-plus)' in F360 post library.

I think Mazak Milling post in F360 library would be reasonably close to your machine NC program. You can download the same in below link:

https://cam.autodesk.com/hsmposts?p=mazak

For detail info about the post editing please refer the  FAQ link

Regards

[Anonymous]

Hi

[endicott.12]

Hello, I was wondering if I could run .eia files on this post processor. I noticed you specified that the other fusion user could use NC files. 

~Thanks, Derick