Fanuc Post Error

[fraction.gp]

Fanuc Mill post

(2D POCKET1)
N30 T8 M06
N35 S5000 M03
N40 G17 G90 G94
N45 G54
N50 M08
N55 G00 X-310.2 Y-80.774
N60 G43 Z20. H08
N65 G01 Z5. F752.
N70 Z4.499 F333.
N75 S19870000
N80 Y-80.81 Z4.117 F700.
N85 X-310.198 Y-80.919 Z3.75

What is the problem here at N75?

King regards

[a.laasW8M6T]

Its hard to know exactly without seeing the Fusion file.

I suspect you have an incorrect Spindle speed value in your toolpath

Check the ramp spindle speed is correct:

If that is fine then you will need to share the .f3d here for analysis

Goto File>Export>Save as .f3d/.f3z 

[fraction.gp]

Thanks

Ramp spindle speed is set to 5000rpm.

I have changed this section to use "bore", but could not load the program into the machine.

It said it was protected.

Will have to try again tomorrow afternoon.

Kind Regards