Drawing Template selection issue

[ubi.james13]

I have a Drawing Template for our company which I'm very happy with, the problem is when I want to make a drawing I select drawing from design ,the  drawing dialog box pops up with my template already selected, I then select OK but a box saying can't find file, I then have to select drawing from design again but this time browse for my template in the pop-up, select it, then on OK it will come up with the warning box saying it can't be found then finally on the third try I select drawing from design , my template is pre selected  but this time clicking Ok take me to my template and all is ok from then on until I shut program down but I usually have to do it all again when starting a new session ! Drives me mad !

[nemadec]

@ubi.james13 

Just as initial steps, Can you try with clearing cache--> Restart Fusion & check if facing the issue.

[ubi.james13]

Cleared Cache same problem !

[nemadec]

Thanks @ubi.james13 

Just few question :-

1. Is template which you are using is in same folder, different folder or different project?

2. Will you be able to share the template for which you facing issue?

[ubi.james13]

1 :-The Template is store in a different Project Folder

2:- https://a360.co/2QsQ2eC pw= letmein

[nemadec]

@ubi.james13 

Can you check link, Not able to access the template.

Thanks 

[ubi.james13]

@nemadec try this link

https://a360.co/3sI4EUy

Sorry for slow reply just very busy, still having  issue ! sometimes its fine other times it's not

[g-andresen]

Hi,

I could select the template from the project folder as well as across projects.
After restarting, it is in the first place after starting the drawing mode.

günther