why is this happening ?

[mreynoldsTPVRE]

So making the model I'm working on and it's tilted, ??  not sure how, or how to fix it. thank you.

[TheCADWhisperer]

@mreynoldsTPVRE 

Did you intend for this to be 3 different bodies at this stage?

with interference between the bodies?

or did you intend to Join?

Is your Sketch3 fully defined?

Did you intend to Cut circles through the part?

[HughesTooling · Accepted solution]

Try resetting the view cube (Reset Front). 

[mreynoldsTPVRE]

Did you intend for this to be 3 different bodies at this stage?

No, but I need bodies 4 an 5 to be 1 inch when joined to body 3 making thickness in them areas 1.5".

Is your Sketch3 fully defined?

I'm not sure, I learned on SW.

Did you intend to Cut circles through the part? No, I need tap holes .75" and 1.25" deep.

 Thank you.

[TheCADWhisperer]

---

@mreynoldsTPVRE wrote:

Is your Sketch3 fully defined?

I'm not sure, I learned on SW.

---

CSWP here since 2007.

Apparently you didn’t have a very good instructor - there is no difference between SolidWorks and Fusion 360.