Unable to find result selector in Static Simulation

[regerohan07]

Hello,

I just did a simple static simulation but cannot switch between results. is the result selector missing, or has it been moved elsewhere?

It is only showing the safety factor. How Do I change it?

[TheCADWhisperer]

@regerohan07 

Does this behavior persists if you reboot the computer?

Can you File>Export your *.f3d file to your local drive and then Attach it here to a Reply?

What graphics card are you running?

[regerohan07]

Hey, @TheCADWhisperer Thank you for your suggestion. I tried restarting Fusion and even rebooting the PC. Still no luck. I've attached the F3D file below. 

I'm running 3050Ti Mobile

[jhackney1972]

Your posted picture is a little too low to show the menu.  There is a drop-down menu as shown by the screen capture below.  This of course is after the study has be completed.

[regerohan07]

Hello @jhackney1972 it is not available in my setup

[jhackney1972]

I do not know what to tell you.  I am showing the result selection for your model on a Windows computer running a standard subscription Fusion 360 license.  I do notice your have a Yellow warning showing on your Results icon in the Browser, maybe you just need to re-calculate your results?

[regerohan07]

I tried that, but it still doesn't show the selection