trouble with lofting 3 profiles

[syd.patterson]

hello all, 

trying to figure out how to use include 3d geometry to connect the rails on these 3 profiles in order to blend them all together, any advice would be appreciated, maybe I just don't have all the numbers defined properly.

[TheCADWhisperer]

@syd.patterson 

Can you File>Export your *.f3d file to your local drive and then Attach it here to a Reply?

Are all of your sketches fully defined?

Are there any unresolved issues highlighted in your Timeline?

Do you have a picture of something similar that already exists in the real world?

I suspect that you will need a Surface Patch.

[syd.patterson]

ive tried to attach it below and redo my steps 

[syd.patterson]

he is another image of the issue

[TheCADWhisperer · Accepted solution]

I didn't take the time to match the bottom side - but I think you can figure out the rest.

Post back if you run into trouble...

You've come a long ways.

I think this could be simplified and also you might want to experiment with Tangent Weight...

@syd.patterson 

I made some revisions...