Hi Support,
I've created a path and a profile but Fusion ignores the path twice:
1. It don't swipes the full path.. even if its fully marked
2. It don't follows exactly the path... there is an additional circle
BR Viktor
Swiping issue
Accepted solution
Here is a much easier way to do this.
The coil tool also allows you to create spirals.
Instead of using a sketch for sweeping the profile, I use the edge of a surface.
If you go through the timeline step-by-step, the workflow should become clear.
At the very least, you should fully define (constrain and dimension) your sketches.
