Selecting edge

[simeonX24F9]

hello

is there a way i can select the edge i show in the picture? i am coming from Solidworks and i was able to do so in solidworks

this is the edge of a round part. and i would normally draw a line from the mid point of that edge to the mid of the circle i am sketching and make the line vertical so that it is in the center and stays in the center if i change the length of the part. 

[TheCADWhisperer]

P for Project and then select the edge to project it into your current sketch (same as Convert Entities in SolidWorks).

Although from your image - if you model with symmetry about the Origin - you could simply select the Origin.  Again, same as in SolidWorks.

[HughesTooling]

If the sketch plane is through the centre of the cylinder you can use Project Intersect.

Or you'll have to project the whole body. Just press P then use the body option.

Mark

[simeonX24F9]

Projecting the body does the trick. Thanks.

It does seem like just a extra step. But it works