Problems with opacity

[Rob_Ellis]

So I have a vise with stock setup to be driven with parameters. I have my stock body set to 50% opacity. It works completely fine, however recently I have run into an issue where whenever I joint a part to my stock, the opacity control goes away and I can't see my part. Of course, I can turn off the stock body which is my current workaround, but obviously I want to find out where my issue is so I can fix it. I may be doing something wrong, but this wasn't an issue until recently. 

I do keep my drivers up to date, and even updated to the newest one as of today just to make sure. 

I'm uploading a screencast right now, I will post it if needed and when its done uploading.

[jeff_strater]

There seems to be a graphics problem that is being worked on.  See this thread: opacity-control-not-working , which contains a workaround.

[Rob_Ellis]

That makes me feel better that I wasn't doing something wrong. haha. Thanks for the info!