Post Process Output Folder resets when restarting Fusion

[matth]

The software used to remember the last location posted to, now it does it but for only the session. Since last update.

[peterson1979]

I'm seeing the same thing @matth. Hopefully they figure this out because it's a little annoying.  

[Anonymous]

I am also experiencing this issue and I hope it gets fixed soon.  @keqingsong 

[fozzy]

This is unbelievably annoying.

Searching for the problem is also kinda hard. There are quite a few reports of the same thing, but worded differently, and i think the issue might be getting ignored because of it.

PLEASE fix this.

[HughesTooling]

I reported the problem a few weeks ago in the manufacture forum here. @seth.madore  acknowledged the problem, but no fusion bug report number so not sure it;s being tracked.

Mark

[seth.madore]

It is being tracked as CAM-23980. It was logged within an hour or being discovered, sorry, I should have posted back.

Good news though; I think the last internal Staging build has this issue addressed. That doesn't tell us anything about WHEN the fix will come out, but just that there IS one.