Need help setting origin

[cjversatile]

I completed this design component but somehow managed to to screw up the origin and I cant seem to fix it.  It's sitting at an angle and below the grid.  Help!

https://a360.co/39ZoLFD

[TheCADWhisperer · Accepted solution]

Right click on your View Cube and select Reset Front.

I immediately notice other issues with your technique.

1. First sketch is not fully defined - this is a major issue going forward.

Duplicate dimensions - unnecessary.

Missing Tangent constraints between lines and arcs. (Use Slot and avoid this issue.)

Did you really intend for the center-to-center distance to be 67.00345367?

I saw multiple other issues going through your Timeline...

See Attached file...

[cjversatile]

Thank you for your help and comments.  I am still relatively new so this is very helpful.  I didnt really intend on anything other than successfully creating the shape but it was more luck than following best practices.   I appreciate it again.