Internal CAM kernel error help

[t.g.mandel]

I have been successfully regenerating various versions of a 2D adaptive tool path, but now I am getting a CAM kernel error. I have attached my file - any help is appreciated.

[t.g.mandel]

I may have found the issue. I had lowered the 'additional offset' in the geometry to 1 mm. When I raised it to 2 mm it generated without the error. if anyone has an explanation I would be happy to learn from it. Thank you.

[seth.madore]

There are many factors that go into whether an Adaptive toolpath fails or succeeds. I think one of the things causing the failure was that you had "Flat Area Detection" turned on, but you also had a value of .0001mm, which is insanely small. Setting it to your tolerance value of .1mm allowed the toolpath to work with all your other settings as you had them.

[t.g.mandel]

Thank you for the reply. I do not remember setting the Flat Area Detection or assigning a value - I will watch for that in the future.