Combining Two Bodies - Lining up the faces

[jmjelonek]

I'm designing a bucket and need to place small part on the bucket, but I'm not sure how to line up the parts properly.  I need the part to line up in the center of the outside of the bucket, 3 of them 120* apart.  Is there a way to setup a grid on the parent part so that when combining, I can get it to snap to the center of the bucket?  Or how do I move the part to the exact center of the bucket wall?

Thanks!

[TrippyLighting · Accepted solution]

If you design the parts in place, there's no need to move them. If you want more specific advice, share the model in .f3d format 😉

[jhackney1972]

If you do not know how to attach your Fusion 360 model follow these easy steps. Open the model in Fusion 360, select the File menu, then Export and save as a F3D or F3Z file to your hard drive. Then use the Attachments section, of a forum post, to attach it.