I am trying to create a solid body having sculpted a form and patched all openings. Even after I stitched everything together, I still observe a hollow body in Section Analysis. I have also tried Boundary Fill, but when I go to select Cells, nothing appears. I'm still learning the software, so I would greatly appreciate any tips.
Cannot create solid body even after stitching
@josephhhaines, it looks like you have some edges that did not stitch. If you start the Stitch command again, you will see some red edges - these show edges that are not stitched, or which are "open" edges (meaning that there is not even a pair edge to stitch with). You'll need to fix those up before either Stitch or Boundary Fill will turn this into a solid.
And, to add a friendly warning: Do not solve this by increasing the stitch tolerance a lot. This approach can sometimes work, but the resulting model is usually problematic. This adds "tolerant edges", which can cause downstream problems. Use this only as a last resort.
Jeff Strater
Engineering Director
