Cann ot post

[jrogers80]

Hello everyone, I am new to fusion and i can not get my first project to post. I keep getting a error. my tool path runs but obviously i have done something wrong. This is quite frustrating and i would prefer someone to talk this over with but fusion does not have support like that. any help would be appreciated.

[julia.paganucci]

Hi @jrogers80 , 

thanks for posting! Can you please post a screenshot of the error you are receiving? It would also be great for me to take a look at your file. What machine post are you using? 

Thanks, 

[jrogers80]

Attached is as screenshot of the error message.

[julia.paganucci]

Hi @jrogers80 , 

no screenshot was attached. can you also attach your file and let me know what post processor you are using? 

Thanks! 

[jrogers80]

Here is a screen shot of the error msg. And also the file that i am trying to engrave on. The holes and contour are for reference only. I just want to engrave the V8 symbol. The machine is a Haas vf2 with a updated control.

[karina.harper]

@jrogers80 

If you're replying via e-mail, you can't attach images. You'll need to navigate to the forum thread and reply in your browser.

Cheers,

Karina

[jrogers80]

I am trying to post a trace tool path so i can use it on a vf2 haas mill. I am sure that i have done something wrong since i am new to Fusion but here is a screen shot of the error msg but i can not find where the file is located to post it in here for you to look at. i can see it in Fusion but i do not know how to show it to you. 

[julia.paganucci]

Hi @jrogers80 , 

Thanks for the screenshot! It looks like you are getting an error mentioned in this article here. 

To export your file follow these directions (file>export and save to your computer as .f3d) or you can share a public link of your design. 

Thanks, 

[jrogers80]

Thank you for the export help. here is the file. As i said before, the holes and the outside radi are for reference only. I only want to engrave the "V8" on my part, I have the part finished except for the engraving. It runs in the simulate mode.

[julia.paganucci]

Hi @jrogers80 , 

I opened your file and there was no part or setup inside the file  was this the correct fusion design file? 

Thanks, 

[jrogers80]

Thank you for all of your help I finally got my file to post. There was no wcs in the setup and i fixed the tool orientation which fixed my problem. Thank you again and as I am new to fusion I am sure that I will have more problems and questions.