Can't pick mesh points for 3 point plane?

[subversivespeed]

tried direct modeling. switched back to parametric. switched back to direct. opened a different file where I know I used 3pt plane. direct modeling. back to parametric. back to direct. Nope. Tried it in a few different tabs, mesh, solid, surface, etc.  Checked ALL on selection filter. Made sure it was enabled. 
Let me know when this can be fixed. I literally used it only a couple days ago. Got the new update and boom its not working. 

[dsouzasujay]

Hi @subversivespeed ,

Thanks for reporting this.

I tested creating a Plane Through Three Points while working in Direct Modeling, and I was able to select the required points successfully.

I’ll share a short video showing the workflow I used to create the 3 point plane in Direct Modeling for comparison.

Could you also share a screen recording showing the issue on your side, including the point where Fusion does not allow you to select the mesh points? If possible, please also show the Selection Filters and the mesh you are trying to use.

That will help us compare the behavior and better understand what may have changed after the update.

Thanks!

[subversivespeed]

Aha... ok.. I found the issue.. 

You can't do it from inside the plane select menu, but, you CAN do it from the main dropdown. 

Just a UI glitch. But the code is still good. 
|
Here you go.. 

[dsouzasujay]

Hi @subversivespeed ,

Thanks for the update and for sharing the recording.

Yes, I can see the behavior you are describing. However, in the video I cannot see the Browser or the Plane selection window/dialog.

Were those areas not recorded, or were they not captured in the screen recording?

If possible, could you share another recording that includes the full Fusion window, especially the Browser and the Plane command options? That will help us confirm the UI behavior you found.