Beginner Training

[Anonymous]

I teach a high school class where we use Fusion 360 tutorials to teach kids about the basics of the program.  I see the getting started training and related topics, but this is not what I used in the past.  In the past, I used a section (that I can't find on the site now), that was a series of video and written tutorials that students could work thru the basics and then use the SW to actually build a design and then test before moving on to the next topic.  Is that still available?  I remember some of the activities were things like building a scissors or an electrical outlet (fully constrained).

Can you help me find these lessions?

Byron

[jhackney1972]

---

@Anonymous wrote:

I teach a high school class where we use Fusion 360 tutorials to teach kids about the basics of the program.  I see the getting started training and related topics, but this is not what I used in the past.  In the past, I used a section (that I can't find on the site now), that was a series of video and written tutorials that students could work thru the basics and then use the SW to actually build a design and then test before moving on to the next topic.  Is that still available?  I remember some of the activities were things like building a scissors or an electrical outlet (fully constrained).

Can you help me find these lessions?

Byron

---

Are you sure you are asking the right forum?  In your question you mention "SW" which most all of the CAD community will interpret as SolidWorks.  This is the Fusion 360 Support Forum.

[davebYYPCU]

I read that as the software.

The Samples directory in your data panel, has quite a few chapters, found the desktop lamp I did, , but have forgotten how to activate the tutorial instructions for it.

Might help....