Why does the tool go up when moving on to the next pass?
Not applicable
08-19-2019
03:05 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
When simulating the 2d contour it does the first level fine, but when moving on to the second level it does a little move upwards at the starting point of the whole cut. How do I fix this, so it doesn't do it and just goes down to the next pass without doing a jump upwards.and then going down. What controls this, because I don't fully understand the heights tab, what each thing does. Could anyone help and fix my problem, I bet it's not even remotely hard it's just Fusion is very confusing for me as a complete beginner. I added my file and a pic below!
THANKS IN ADVANCE!
this little hop
Fusion