I need to Thread mill some 1 3/4"-8 internal threads in a blind hole. I have selected a scientific cutting tools SPTM745 single point thread mill (specs pictured below). my problem is that when i run the simulation fusion decides to blow out the entire wall (like it is a flat endmill) instead of just where the point of the thread mill is cutting. anyone have any idea why this is happening?
Have you got the simulation mode set to standard?
Mark
Mark Hughes
Owner, Hughes Tooling
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
Can't find what you're looking for? Ask the community or share your knowledge.