Discovered I'm having an issue HAAS Next Generation Control post processer, after the weekend update. I'm going in and noticing that all the prior changes I have made are intact, but it seems like it has defaulted back to its original settings. Unfortunately, this leaves me unable to run a program without editing. I have verified that is is looking at the correct subfolder on my C drive. Does any one have any suggestions to try?
My changes made
1. Reduced high feed rate to 500ipm from 650ipm.
2. Changed the Z axis home position to 4.4 inches
3. Retracting the Z axis to home position after each tool change.
