Internal CAM Kernal Error

[jta49]

I am receiving the "Internal CAM Kernal Error" again... I've followed what other older blog posts have done to fix it but have had no luck. Any Ideas?

[seth.madore · Accepted solution]

The issue is stemming from your Heights tabs. However, I'm curious about your Setup. You've selected the base component, but then you are making a chain around the little posts that are not included in the Setup. What's your goal here?

[HughesTooling · Accepted solution]

I found I needed to select the whole component and I think you need to click the red arrow to switch the offset to the outside. There's still a warring about heights as @seth.madore  mentioned.

[jta49]

Ahhhh... Ive been working to fast and botched my setup. Thankyou for the help, works now.