Accurate Cycle Time Estimates

[joeymorgans]

I have edited the feedrate ratio and tool change time in the Machine Definition as shown below:

But these don't seem to come across in the actual set ups machining time calculations:

I thought if it is zero, then it will perhaps refer to the machine file, but that doesn't appear to be the case. Is there anything else I can try?

Before anyone asks, I did check I re-selected the new machine definition in the set-up.

I would also like to know the parameter names for the feedrate ratio % and tool change time in the machine definition, as I would like to use these in a calculation in my post processor too.