Y-axis toolpath problem

[kalinkinandrei]

Hello,

I have the following silly problem:

Most of the cutting of the below part I need done along the X-axis.

But the last fillet part (as I only have a flat bit atm) I would like to do along the Y axis.

For some reason I get toolpaths only for the X-Axis and I do not know how to change that.

Any help much appreciated and many thanks ahead.

[Steinwerks · Accepted solution]

In the Passes tab change the Pass Direction to 90°. You can also use this to alter the direction from which the cut starts.

[kalinkinandrei]

Thank you very much!

Just a minute ago actually by accident found the same solution on one of NYC CNC youtube videos.