Turning from negative X direction

[rahook]

Fusion is not playing well with the Tormach Turning post-processor.  When I make my setup in Fusion, I only have the option for Radius as the radial dimension mode.

The post-processor for Tormach runs as G7 (diameter).  When I create a profile, it builds the profile correctly and the simulation plays as I would expect.  However, when I post the profile and open it in PathPilot it seems that the X-axis has been inverted or that the tool is cutting from negative X--which would obviously cause the tool to crash. 

[narzinskin]

if you are using the tormach turning pathpilot post, this info is at the top of the post and should be of use:

///////////////////////////////////////////////////////////////////////////////

// Turret Assignments

//

// The following tooling options are controlled by the Turret number associated

// with the tool in the tool library.

//

// Turret 0 = Positional Turret

// Turret 1 = Quick Change Front Tool Post

// Turret 2 = Quick Change Rear Tool Post

// Turret 3 = Gang Tooling on Front Tool Post

// Turret 4 = Gang Tooling on Rear Tool Post

//

///////////////////////////////////////////////////////////////////////////////